| |
|
 |
Y39-3 2bbl Rochester
Choke on Top |
| All Y39 type carburetors have two idle mixture screws. However, there are variations in the choke, position of the gas inlet, the type of linkage, and bore size. |
|
|
 Click picture for close up view |
The Y39-3 carburetor that you have chosen has the following variations.
|
Stock # |
Engine Size |
Choke Type |
Gas Inlet Position |
Linkage Type |
Bore Size |
Y39-3 |
4 Cylinder
120/140
2.5L/3.0L
|
Electric |
Female
Choke Side
|
Single Hole |
Small |
|
The Y39-3 carburetor should look similar to the pictures below, don't expect each picture to
look exactly like your carburetor. View all the variations below for the Y39-3 carburetor and if this is the caburetor you need, order it at the bottom of the page. If NOT Click Here
|
Click picture for close up view |
Choke Type
|
|
|
|
Down (Hot Air)
|
Side (Hot Air) |
Electric
Y39-3
|
|
Click picture for close up view |
Gas Inlet Position |
|
|
|
|
|
Female (Front) |
Male (Front) |
Female (Choke Side)
Y39-3
|
Male (Choke Side)
|
|
Click picture for close up view |
Linkage Type |
|
|
Carburetors where the throttle linkage hooks onto the bottom can be bolted directly into the carb linkage or have an add on bracket (like at right) or a similar type that bolts to the top and bottom of the carburetor linkage. |
|
2 Hole Bottom
|
2 Hole Bottom
|
Bolt on Pieces
|
|
|
Single Hole Stud Top
Y39-3 |
|
Click picture for close up view |
Bore Size |
|
|
|
|
|
| |
Small Bore 1 3/8 Inches
Y39-3 |
|
Large Bore 1 5/8 Inches |
|
|
|
|
|
|
|
|
|
)
)
)
)
)
)
){kind=small}